1
11
1
Safety
• Read this manual carefully before operating the
equipment and follow the instructions.
• Installation, operation and maintenance should be strictly
accordance with this manual, national codes and good
practice. Installation or operation not performed in strict
accordance with these instructions will void
manufacturer’s warranty.
• Disconnect all power inputs before servicing the soft-
starter and/or the motor.
• After installation, check and verify that no parts (bolts,
washers, etc) have fallen into the power Section (IP00).
Attention
1. This product was designed for compliance with IEC 947-4-2 for class A equipment and EN 50178.
2. For further information see Technical Specification
Warnings
• Internal components and P.C.B’s are at main potential
when the HRVS-DN is connected to main voltage. This
voltage is extremely dangerous and will cause death or
severe injury if contacted.
• When HRVS-DN is connected to the main voltage, even
if control voltage is disconnected and motors is stopped,
full voltage may appear on starter’s output and motor’s
terminals.
• Unit must be grounded to ensure correct operation, safety
and prevent damage.
• Check that Power Factor capacitors are not connected to
the output side of the soft starter and confirm that they are
connected upstream to the line contractor.
The company reserves the right to make any improvements Or modifications to its products without prior notice.
To Next Page
Loading...
Need help?
General
