To Next PageTo Next PageWhat to do if my SOLIS Inverter displays OV-DC01 (1020 DATA:0001) error?
If your SOLIS Inverter displays OV-DC01 (1020 DATA:0001), check if the PV voltage is abnormal. Restart the system and confirm if the fault continues.
What does Fan Alarm mean on my SOLIS S6-GR1P6K, and how can I fix it?
If your SOLIS Inverter displays Fan Alarm, check to see if the internal fan is working correctly or if it is jammed.
How to turn on SOLIS Inverter?
If your SOLIS Inverter is 'Off', turn on the device using the ON/OFF Setting.
What should I do if my SOLIS S6-GR1P6K shows UN-Vbatt?
If your SOLIS Inverter displays UN-Vbatt, restart the system to see if the fault clears. If the issue persists, it's recommended to contact the manufacturer's customer service for further assistance.
What does OV-Vbatt mean on my SOLIS Inverter, and how do I resolve it?
If your SOLIS Inverter displays OV-Vbatt, verify that the battery voltage is within the specified standards. Measure the battery voltage at the inverter connection point. If the issue persists, contact your battery manufacturer for further assistance.
What causes CAN Fail on my SOLIS S6-GR1P6K Inverter and how can I fix it?
If your SOLIS Inverter is showing a CAN Fail error, check the cable conditions and ensure it is properly plugged into the CAN port of both the battery and the inverter. Verify that you are using the correct cable. Some batteries may also require a special cable from the battery manufacturer.
What to do if my SOLIS S6-GR1P6K Inverter displays Over-Load?
If your SOLIS Inverter shows Over-Load, you need to reduce the amount of backup load or remove any inductive loads from the backup system.
What to do if my SOLIS Inverter shows OV-G-V01 error?
If your SOLIS Inverter displays OV-G-V01 error, ensure the power grid is working normally and the AC cable is properly connected. If the issue continues after these checks, restart the system to see if the fault clears.
What does Fan Alarm mean on SOLIS Inverter?
If your SOLIS Inverter displays 'Fan Alarm', check if the internal fan is working correctly or if it is jammed.
What does BatName-FAIL mean on SOLIS Inverter?
If your SOLIS Inverter displays 'BatName-FAIL', confirm that the battery model selection is consistent with the actual battery you are using.
General| Model | S6-GR1P6K |
|---|---|
| Rated Output Power | 6000 W |
| Max. Input Voltage | 600 V |
| Start-up Voltage | 90 V |
| Number of MPPT Trackers | 2 |
| MPPT Efficiency | 99.9% |
| Nominal AC Output Power | 6000 W |
| Nominal AC Voltage | 230 V |
| AC Voltage Range | 180-280 V |
| Nominal Grid Frequency | 50/60 Hz |
| THDi | <3% |
| DC Connection Type | MC4 |
| Protection Degree | IP65 |
| Topology | Transformerless |
| Cooling Method | Natural convection |
| Max. DC Input Power | 9000 W |
| Max. AC Apparent Power | 6000 VA |
| Operating Temperature Range | -25°C to 60°C |
| Type | Single-phase inverter |
