Chapter 5 RAID Controller
89
4. Using the Spacebar, choose “Security” under the Optimize Array
for section.
5. Press <Ctrl-Y> keys to Save your selection.
3. Press “1” to display the Auto Setup Menu below. This is the fastest
and easiest method to create your first array.
[Auto Setup Options Menu]
Optimize Array for: Performance
[Array Setup Configuration]
Mode ............................................... Stripe
Spare Drive .............................................0
Drives used in Array ................................1
Array Disk Capacity .........................38166
[Keys Available]
[] Up [] Down [,, Space] Change Option [ESC] Exit [Ctrl-Y] Save
6. Reboot your system.
7. Once the array has been created on new drive(s), you would need to
FDisk and format the array as if it were a new single hard drive.
8. Also proceed to “Installing Drivers” section of this Chapter for system
and FastTrak 376 Driver setup.
To Next Page
Loading...
