Chapter 5 RAID Controller
91
5-2.1-2 Installing Driver To Existing Win 2000/XP System
At booting with Windows 2000/XP system and your hard drive(s) con-
nected to IDE1/2, Windows 2000/XP setup will show a “New Hardware
Found” dialog box. Under Windows 2000/XP, the “PCI RAID Controller”
will be displayed.
1. In the dialog box, choose “Driver from disk provided by hardware manu-
facturer “ button.
2. In the A: drive, insert the FastTrak 376 driver diskette.
3. Type “A:\WIN2000/XP” in the text box. Press “Enter”.
4. Choose ”Win2000/XP Promise FastTrak 376 Controller” from the
list that appears on screen, then press the “Enter” key.
5. The Windows 2000/XP setup screen will appear again saying “Setup
will
load support for the following mass storage device - Win2K/XP Promise
FastTrak 376 controller. The FastTrak 376 driver will now be copied
on to the system and entered into the Windows 2000/XP driver
database.
6. When the “System Setting Change” dialog box appears, remove
the floppy diskette and click on “Yes” to restart the system. Win
2000/XP will then restart for the driver installation to take effect.
7. Power off your system, then attach your hard drive to the FastTrak 376
controller, e.g. IDE3/ATA1/ATA2.
WARNING:
WARNING:
Your must first complete installing the driver before
moving the boot drive containing the existing Windows 2000/XP
operating system on to the FastTrak 376 controller (e.g. IDE3/ATA1/
ATA2). On mainboard, IDE1/2 are for system IDE controller, while
IDE3 & ATA1/2 are under RAID controller.
Note: If you need to specify any additional devices to be installed, do
so at this time. Once all devices are specified, continue to step 7.
7. From the Windows 2000/XP Setup screen, press the Enter key. Setup
will now load all device files and then continue the Windows 2000/XP
installation.
To Next Page
Loading...
