16 System Messages | Labstamp User Guide | PN: 1202.D
Tail oil • • • • • •
ETO= Ethylene oxide
VHP= Vaporized hydrogen peroxide
The Applicator Machine can fit inside an isolator with a 12” diameter transfer portal.
WARNINGS
The Applicator Machine has electrical components that can be damaged by autoclave processes.
The external surfaces of the machine can be cleaned with any sterilant or disinfectant solution.
Do not spray any liquid (including sterilant or disinfectant) directly into the docking port or air vents,
located on the back.
Section 5 System Messages
Message What it means
ENTER MOUSE ID
_ _ _
Appears in the Manual Entry option. In this option, a new ID
will need to be entered for each mouse.
ENTER FIRST ID Appears in the Auto Increment option. See rules on page 13.
TATTOOING IN PROGRESS The machine is tattooing a mouse. Do not remove the
Restraint Cartridge from the docking port until the
RESTRAINT CARTRIDGE STATUS light returns to green.
NEXT MOUSE ID _ _ _
PRESS START
In the Auto Increment option, the next number in the sequence
automatically appears. Press START to begin tattooing.
REPLACE NEEDLE 50 tattooed IDs have been applied. The needle must be
replaced. Will stay on until the new needle has been installed.
REMOVE RESTRAINT CARTRIDGE Usually appears after pushing the CHANGE NEEDLE button.
The Restraint Cartridge must be removed before changing the
Needle Cartridge.
PLEASE WAIT The tattoo head is either extending out of or retracting into the
machine. Wait until the tattoo head stops before attempting to
change the Needle Cartridge.
AUTO INCREMENT
MODE ON
The Auto Increment option has been turned on.
AUTO INCREMENT
MODE OFF
The Auto Increment option has been turned off.
To Next Page
Loading...
