19 Troubleshooting | Labstamp User Guide | PN: 1202.D
6.3.2. Using a small thin screwdriver, insert it partially into one of the air vents of the Backplate where
the fan is installed.
6.3.3. Pull back lightly on the screwdriver until the Backplate is aligned with the groove on the
underside of the Top Cover.
Caution: Use only a very light force when pulling back on the screwdriver. The Backplate is fairly
loose at this point and will readily respond.
6.3.4. Finish lowering the Top Cover until its rear alignment groove fully seats onto the Backplate.
6.3.5. Remove the screwdriver.
6.3.6. Inspect the seating of the Top Cover onto the Machine.
6.3.6.1. Inspect to ensure that the front interface of the Top Cover is evenly seated across the
seam of the Faceplate, and that the rear groove of the Top Cover is fully engaged and
seated onto the Backplate.
6.3.6.2. Inspect to ensure that the rounded left and right seams of the Top Cover match-up and
are flush with the radius of the blue Bottom Cover.
6.3.6.3. If the Top Cover is misaligned, repeat steps 6.3.1 -6.3.6 until it is aligned properly.
6.3.7. Keeping the Machine upright, slide it forward until one end overhangs partially the edge of the
work table.
6.3.8. Using the 9/64” Allen hex key, install two (2) of the socket head cap screws from underneath the
Machine and tighten them until slightly snug.
6.3.9. Still keeping the Machine upright, rotate it 180 degrees and slide it forward until the other end
overhangs partially the edge of the work table.
6.3.10. Install the two (2) remaining socket head cap screws from underneath the Machine and tighten
them until slightly snug.
6.3.11. Re-inspect the seating of the Top Cover to the Machine, making sure that all interfacing seams
are still flush.
6.3.11.1. If the Top Cover is misaligned, repeat steps 6.3.1-6.3.11 until it is aligned properly.
6.3.12. Tighten the four (4) socket head cap screws until they are snug.
6.3.13. Caution: Do not overtighten the screws as they may crack the plastic Bottom Cover.
6.3.14. Plug the power cord back into the back of the Machine.
6.3.15. Turn ON the power using the rocker switch in the back of the Machine. The Machine is now
ready for use.
To Next Page
Loading...
