10
NOTE Skip steps 2f and 2g if your tilt mechanism uses a wand.
2f. To remove the tilt cords: Use scissors to snip the knot at the end of the cord, beneath the tassel. Cut as close to the knot as possible.
Then pull the cord up and through to remove the tassel.
NOTE: Be certain you are cutting the TILT CORDS and NOT the LIFT CORDS.
Slide tassle off cord
2g. Gently pry away the tilt mechanism, as shown, then remove it along with the tilt cords. NOTE: A screwdriver may be helpful in prying
away the tilt cords mechanism.
Pull cords out through holes in headrail
To Next Page
Loading...
