Page 10
1.4 What’s Included
Your Series 300 Eight Channel package contains the following items:
One Series 300 unit (Model 303, 304 or 305)
One IEC mains or power cord, appropriate for your area
One 24 Volt, 48 Watt, world-ready external power supply
One 0.5 meter, IEEE 1394a, 6 pin FireWire cable
One Software Install CD, containing Sonic Console software, firmware and an
Extras folder
Rack Mount Kit
This Quick Start Guide
1.5 Additional Cabling
DB25 or DSub male to XLR or TRS cables to connect your Series 300 Interface to
your analog and digital equipment:
One DB25 to XLR female or TRS for 8 channels of audio input
One DB25 to XLR male or TRS for 8 channels of audio output
One DB25 to four XLR male plus four XLR female for 8 channels of AES digital input/
output
One DB25 to XLR female for 8 channels of microphone input (305 only)
Two 1/4” TRS male cables for L and R main outputs
One or two 110 Ω, BNC coaxial cable for word clock connections, if needed
One 110 Ω, BNC coaxial terminator for word clock connections, if needed
One 110 Ω, BNC “T connector” for word clock connections, if needed
One or two 1/4” TRS male and/or female cables for SMPTE/EBU LTC connections, if
needed
1.6 Software Installation — Driver & Firmware
Please load the included CD into your drive and carefully read the enclosed Series300_Read-
Me_Installing document. In addition, the CD contains specific instructions on the installation of
driver and firmware for your converter.
If you are using an Intel Mac as your host, please pay special attention to the Aggregate Audio
Device instructions.
1.
2.
3.
4.
5.
6.
7.
8.
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...