Sontex 56 Series User Manual

11
Instruction for Use | HCA 56x and 8x8
2.4.2 Installation with Glue
Due to their chemical composition, adhesive assemblies release vapors and can damage the
plastic housing of the heat cost allocator. Sontex recommends the use of Pactan silicone from
Tremco Illbruck GmbH.
2.5 Disposal
To preserve and protect the environment and reduce waste of natural
resources and pollution, the European Commission has adopted a directive
whereby electrical and electronic equipment is taken back by the manufac-
turer for proper disposal or recycling
If you carry out the disposal, the heat cost allocator must be disposed of
under the applicable local environmental regulations. Find out about recy-
cling opportunities in your region
This symbol indicates that electrical and electronic equipment must be
disposed of separately.
The following applies to consumers in European countries:

This product must be disposed of separately at a suitable collection
point. Do not dispose of it with your household waste!

Through separate disposal and recycling, natural raw materials can
be preserved and the harmful consequences for human health and the
environment caused by incorrect disposal can be prevented.

Further information can be obtained from your specialist dealer or from
the authorities or companies responsible for waste disposal.
2.6 Warranty
The warranty rights are only valid if the devices have been installed and used in compliance
with regulations and if the technical guidelines in force have been followed.
2.6.1 Compliant Use
Installation of this product must comply with the installation directives described in this manu-
al and carried out by personnel trained for this purpose.
2.6.2 Non-compliant Use
Any application other than that described above is not permitted.
2.7 Notes regarding Installation
Any inappropriate handling or faulty installation may result in radiator leakage. Please respect
the recommendations of the installation notice for the radiator.
2.8 Protection against Outside Influences
2.8.1 Lead seal
The heat cost allocator is closed with a safety seal which cannot be removed without caus-
ing damage. It is therefore impossible to open the device without this being detected. After
installation, the electronic part of the device is no longer accessible. The LCD display, the push
button and the optical interface are protected. It is impossible to access the interior of the
device without damaging it.

Sontex 56 Series Specifications

General

Brand	Sontex
Model	56 Series
Category	Measuring Instruments
Language	English