16
Instruction for Use | HCA 56x and 8x8
4. Settings
4.1 Article Coding System
Sontex gives each customer the option of defining the different configuration settings as well as
a personalised logo (for a one-off initial fee) in place of the Sontex logo.
To distinguish between configurations, a unique article number will be assigned to each of the
configurations.
The article number includes 11 characters (e.g.: 0868R20S000).
The article number consists in:
4 numbers for the model type:
Sontex 565 = 0565
Sontex 566 – SONTEX Radio = 0566
Sontex 868 – wM-Bus Radio = 0868
Sontex 878 - LoRaWAN® Radio = 0878
1 letter to define the aluminium back plate:
Sontex-Aluminium plate = R
Kundo-Aluminium plate = X
6 characters designating the customer specifications. Theas 6 characters are defined by
Sontex:
Characters 1-2 : reserved for Sontex.
Characters 3-4 : Sontex representative / customer.
Characters 5-6 : Final customer, Logo, language and settings.
For each heat cost allocator model, it is possible to plug the remote sensor's connector into
an interface inside the allocator. As such, there is no article number for a heat cost allocator
equipped with a remote sensor.
4.2 Settings
The following table can be used to determine the configuration of the heat cost allocator by
combining the different settings options that follow.
Please ask us for a setting sheet if you want to order new heat cost allocators or change your
current settings.
Due to distinctive technical features, not all possible combinations are necessarily
achievable.
To Next Page
Loading...
Need help?
General
