43
Instruction for Use | HCA 56x and 8x8
7.8 Mounting and Sealing
After installation of the respective fastening-parts kit to the radiator, the heat cost allocator
can be mounted and sealed by the installer as described below:
The heat cost allocator is placed at the upper end of the
aluminium back plate. Move the heat cost allocator down
so that the hooks in the housing fit in the aluminium back
plate.
The heat cost allocator is placed on the aluminium back
plate in the direction of the arrow.
As soon as the heat cost allocator is fixed to the aluminum
rail, hes display will show the following message:
The index FF indicates that the splitter has recognized the
remote sensor.
The index -- indicates that the heat cost allocator is
working with a compact radiator sensor or that it has not
recognized the remote sensor.
This information will be displayed for 5 seconds, after
which the heat cost allocator will automatically change
modes.
Push the seal pre-installed by Sontex in the slot of the
housing, then press until the seal clicks into the aluminium
back plate.
Now the heat cost allocator can only be opened by destroy-
ing the seal.
To Next Page
Loading...
Need help?
General
