*Strip about 10 mm (13/32 inches) of insulation from the speaker cable at each end.
Note
To prevent the wires of the speaker cable from touching each other, make sure not to
strip too much of the speaker cable.
Connect the speaker cable properly so that the polarities (+/-) between the TV and AV
receiver match.
Related topics
Connecting an audio system
[63] Audio system (such as an AV receiver or sound bar) | Audio system (such as an AV
receiver or sound bar)
Pass-through audio formats supported with eARC
Confirm that you can pass-through the following audio formats.
7.1 channel linear PCM: 32/44.1/48/88.2/96/176.4/192 kHz
Dolby Digital
Dolby Digital Plus
DTS
Dolby TrueHD
DTS-HD MA
DTS:X Master Audio
For details, refer to the support page.
Support Site
Related topics
Connecting an audio system
To Next Page
Loading...
