ff dust or debris enters the camera and lands on the image sensor (the part
that acts as the fihn), it may appear on the photo image, depending on the
shooting environment. If there is dust on the image sensor, use a
cormnercially available blower and clean the image sensor following the
steps below'. You call easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be perlormed only when lhe battery level is t[_] (lhree remaining
battery icons) or more. Low banerv, power during cleaning can cause damage to the
shuner. The cleaning should be compleled quickly. The use of an AC-PWIOAM AC
Adaptor (sold separately) is recommended.
• Do not use a spray blower because it may scatter water droplets inside the camera
body.
1Confirmthatthebatteryisfullycharged(page18).
2 PresstheMENUbutton,then
select',_ 3with</1_onthe
controlbutton.
...._;iii!i;!i!i!!!i!ili!iiiililililililiiiiiiiiiiiiii!!iil;¸¸¸¸,
MENU button
3 Select[Cleaningmode]withA_,
thenpressthecenterofthe
controlbutton.
The message "Alter cleaning, turn
camera off. Continue?" appears.
iiiiiiiiiiiiiiiiiiiiiiiiiii_i_i]iiiiiiiiii!i!!ii_!ii!ii_iiii_
4Select[OK]with• onthecontrolbutton,andpressthecenter
ofthe controlbutton.
Alter the image sensor vibrates for a short time, the mirror in front is lifted.
g
g
33
To Next Page
Loading...
