Important
Safety
Instructions
1 _ Readthese instructions
21 Keep these instructions.
3 _ Heed all warnings.
4t Follow all instructions.
5 b Do not use this apparatus near water.
61 Clean only with dry cloth.
7} Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
USE
AC power cord
Observe the K_llowings m prevent tile AC' power cord fl'onl being
dmnaged. If the AC power cord is damaged, it may result in a fire or an
electric shock. Stop using it and ask your dealer or Son? ,ervme cen_er m
exchange it.
[] Do not place the TV where the power cord is subject to wear or abuse
[] Do not pincll, bend. or twist the cord excessivdy. Tlle core lines may
be bared _md CUT.Causing a short-circuit, and resulting in a fire or nn
electric shock.
[] Do not convert or damage the po,_ er cord.
[] powerD°not allow mlythin_ TOrest on orroll overthecord.
[] Do not move die TV with the power cord
plugged im
[] Keep the power cord away t;rom heat sources
[] When you disccmnect the AC power cord.
disconnect it f_om the wall outlet first.
[] Be sure to grasp tim plug wtien disconnecting the power cord. Do not
81 DO not install near any heat sources such _ ,_,,, t << pull the power cord.
as r diat r heat re isters stoves r _b_: rq Do not use the supplied AC power cord on any other equipmenl
• a " O s_ ' g ' ,', ; ', 0 _-_ I_
.... . , ,. ,._. , _[__._ N Else only an original Sony AC power cord. not other brmld_.
otner apparatus _mcmtung ampnners_ _"1
that produce heat. Jllllll[]llllllll Wall outlet
91 Do not defeat the safety purpose oflhe polarized ol
grounding-type plug. A polarized plug has two
blade_ with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. Iflhe provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outleL
10t Protect tile power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where the} exit from the
apparatus.
11) Only use attaehments/aecessories specified by the
manufacturer.
12} Use only with the cart. stand, mpod,
bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used. use
caution when moving the cart!apparatus
combination to avoid injury from lip-over.
l 3 } Unplug lhis apparatus during lightning storms or
when unused for long periods of time.
14 _Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in auy way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, lhe apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
The TV set wifll a three-wire grounding type AC
power cord plug must be connected to an AC power _
socket outlet witli a protective earthing connection.
Do not use a poor fitting outlet. ,"_F/
Insert the plug fully into the outlet. If it is loose it may
cause arcing and result in a fire.
Contacr your electriciml to buve the outlet clmnged
When connecting cables, be sure m unplug the AC power cord fL_ryour
s_,fkTy
Take care not to catch your feet on the cables. It may damage the TV set.
Electric shock p_
Do not touch the AC power cord or tim TV with a L_ _l)
wet halld. If you plug/unplug the AC power cord %__7/"; - _-a
fl'om the TV witl .... t hand. it may ....... lectric _1_
shock
- Lightning storms __,,
For added protection for thi_ TV during a __-
lightning s_orm or when it is left unattended
and unused for long periods of time. unplug
it f}om the wall outlet and disconnect *tie
antenna. This will prevent damage to the TV
due to lighming and power line surges.
When not in use
If you will not be using the TV set fl0r several da 3,. the TV set should be
disconnected i_om tim AC power outlet for environmental and saf_t}
reasons. The TV set is not disconnected fi'om tile AC power source when
the TV set is switched off. To disconnect the TV set completely, pull tim
plug t?om the AC power outlet.
Overloading
Tlds TV set is designed to operare on a
120- 240 V AC supply only Take care not to
connect Ioo mmly applimlces to the same AC
power outlet as this could result in a tire or all
electric shock
Optional equipment
Do not install optional equipment too close to tile TV set. Picture
dist _rtion and!or noisy sound may occur if the TV set is positioned in
close proximity to any equipment entitting electromagnetic radiation.
4
To Next Page
Loading...
Need help?
Power
Display
Inputs and Outputs
Weight and Dimensions
