95
Troubleshooting
Others
Symptom Cause Solution
Your camera does not
work.
• You are not using an “InfoLITHIUM” battery
pack.
• The battery level is low. (The E indicator
appears.)
• The AC Adaptor is not connected securely.
p Use an “InfoLITHIUM” battery pack (page 109).
p Charge the battery pack (page 11).
p Connect it securely to the DC IN jack of your camera and to a
wall outlet (page 14).
The power is on, but the
camera does not work.
• The built-in microcomputer is not working
properly.
p Disconnect, and then, after one minute, reconnect all power
sources and turn on the camera. If this does not work, press the
RESET button on the bottom of the camera using a fine-tipped
object, then turn on the power again. (All the settings including
date and time are cleared.)
You cannot identify an
indicator on the screen.
— p Check the indicator (page 113).
The lens gets fogged. • Moisture condensation has occurred. p Turn off the camera and leave for about an hour at room
temperature for the moisture to evaporate before use (page 108).
A file error occurs when
you play back a file.
• The image file has an error.
• The image was not recorded correctly.
• The disc is dirty
• The disc may be scratched.
—
—
p Clean the disc (page 108).
p Replace the disc.
To Next Page
Loading...
