Sony CDP-3100 - Dabk-3101 Memory Board; Installation; Operating Conditions; Supplied Accessories

SECTION 1
INSTALLATION
1-1, OPERATING CONDITIONS 1-2. SUPPLIED ACCESSORIES
Operating temperature : 5°C~40°C (1) CDP-3100
Storage temperature : -—20°C to 55°C Power cord 1
Weight : 6.5 kg (CDP-3100) Player No. seal 74
700g (CDS-3100) Maintenance manual part 1 : 1
Locations to avoid: Operation manual 1
e Areas where the unit will be exposed
to direct sunlight or any other strong (2) CDS-3100
lights. Joint |
e Dusty areas or areas where the unit Screw (+B3 x 6) :2
will be subject to vibration. Connecting cable 71
e Areas with strong electric or Piayer No. seal 4
magnetic fields. Operation guide 1
e Areas near heat sources
e Areas where the unit will be subject
to vibration.
e Areas with a lot of electrical noises.
e Areas where static noises easily
occur. 1-3. OPTIONAL ACCESSORIES
Note for installation: CDS-3100 : COMPACT DISC PLAYER CONTROL UNIT
The rear side must be at least 40 cm DABK-3101 : MEMORY BOARD
away
from
the
walis
for
ventilation
DABK-3102
:
SONY
INTERFACE
BOARD
and
maintenance.
DABK-3103
:
SONY
INTERFACE
BOARD
When
using
the
unit
on
a
desk,
etc.
leave at least 40 cm at the top for
servicing of the print board.
But this space need not be left if the
unit is mounted in a rack because
maintenance of the print board can
be carried out by pulling out the unit.
The unit has been designed to be
used upright.
Therefore do not place it on its side
nor tilt it.
CAUTION
Laser beam
When servicing, do not approach the laser exit with the eye
too closely. in case it is necessary to confirm laser beam
emission, be sure to observe from a distance of more than
30 cm from the surface of the objective lens on the optical
pick-up block.
CDP-3100
4-1
(E)