Sony CDP-3100 - Checking CDS-3100

(2)
Press
the
following
key
switches.
(Checking
the
key
switches)
The
display
(disc
data
display)
will
show
the
following,
according
to
the
key
switch
pressed.
Display (Disc Data
Display)
PREVIOUS
4219
3/219
gO @
OPEN/CLOSE
Pere
"d.iP.-..-.3"
ajejelelelele|
®
@
° .
,
PREMOTESPLAY
[PLAYS
|
elele|ei¢
ECE
(3)
After
checking
the
key
switches
and
the
lighting
of
the
LEDs,
tum
off
the
POWER
switch.
(4)
After
turning
off
the
power
switch,
set
the
normal
state
for
operating
the
unit
by
turing
it
on
again.
2-6 (E)
2-5-2. Checking CDS-3100
CDS-3100 has a function (test mode) for checking the key
switches and lighting of the LEDs on the panel.
Use this function after carrying out repairs (replacing the
boards of CDS-3100, etc.).
Before Checking
1. Remove the bottom plate of the CDS-3100 remote
control unit.
2. Connect the CDP-3100 unit and remote control unit with
the connecting cable supplied.
Setting the Test Mode
1. Set switch $7 of the KC-30 board (A-side) of CDS-3100
to "TEST".
CDS-3100
TEST~—NORM
KC-30 board
Procedure
(1)Tum on the POWER switch of CDP-3100. (Checking the
fighting of the LEDs)
Check that:
After all LEDs on the panel light up for about five seconds,
the following LEDs light up at regular intervals.
These
LEDs
continue
lighting
up
until
any
one
key
switch
is
pressed.
TRACK NO.—INDEX-—VARI SPEED % MIN
GARI SPEED % SEC->VARI SPEED % FRAME
GET TIME>REM TIME-ACT TIME
LTIME CODE SMPTE ND-TIME CODE SMPTED—
TIME CODE EBU-ON AIR-2ON LINE-STAND BY
CvARI-VARI SET>AMS-— SINGLE PLAY->INDEX
CL,FADER->SKIPSTOP-»PLAY-STAND BY—JOG
GuINE OUT
CDP-38 00