Sony CDP-3100 - Securing Cds-3100; Input;Output Interface; Connector Input;Output Signal

1-8. SECURING CDS-3100
By using the joint provided, several sets of CDS-3100 can be
secured to each other side by side.
Note:
When
lifting
up
two
or
more
CDS-3100s
which
are
connected,
be
sure
to
hold
both
sides
of
the
units.
Parts to prepare
Joint ‘(supplied with CDS-3100)
Attaching screw :4 (supplied with CDS-3100)
Procedure
1.
Temporarily
attach
the
joint
provided
to
the
rear
of
CDS-
3100
at
the
screw
holes
with
the
four
screws
(provided).
2. Set CDS-3100 properly and tighten the screws.
Tightening torque:1.0 Nem (10 kgecm)
Screw (+ B3 x 5)
Screw (+ B3 x 5) ?
CDS-3100
CDP-3100
1-9. INPUT/OUTPUT INTERFACE
1-9-4. Connector Input/Output Signal
The input and output signals of the connector panel section
are as follows.
CDP-3100
LINE OUT CH-1, CH-2; Analog audio signal
Reference output level
(+4 dBs, 6002 ohm balanced load)
Max output level!
(+19 dBs, 6002 ohm balanced load)
DIGITAL OUT AES/EBU; Digital audio signal, AES/EBU
format
MONITOR OUT CH-1, CH-2; Analog audio signal, 0 dBs
(Load impedance, 47 KQ )
REMOTE-1
"|e leet (Peat
Fi [OnTA [son] Dia anode oan
ra [ofr o)_[nssaea| sea coro oral ert
ra [o[isv |= [Power sy
[a To [sv —| = [Powersippy |
rs [ofc Rate Ser cone oral a
Es
id
[7 [—|renn [| — [eno
[8 | 1 [CMD (-) |RS-422A| Serial control signal ipput (-) |
[9
|
0
[DATA
(+)|RS-422A
|
Digital
audio
signal
output
(+)
[10 | 1 [OM (+) |FRs-422A] Serial control signal npout(+)_|
REMOTE-3: Refer to the operation manual.
15 (E)