Sony CDP-3100 - 1-11.Displays When Power Is Turned on

1-11. DISPLAYS WHEN POWER IS TURNED ON
This section describes the displays that are shown on the
CDP-3100 and CDS-3100 displays (disc data display) when
the power is turned on.
The following are shown on the CDP-3100 and CDS-3100
displays (disc data display). Each display will be shown for
about two seconds.
Note-* indicates blank display
1.CDP-3100
CDP-3100 Display =
| |tiecomacimay | Preis [renee
pee [ecm |
XXX:Version No.
reer eee
origin code
Option displays Shown when the
@Op t* 31 01 following optional
L
boards
(D,
@,
®)
are mounted
@DABK-3101
@DABK-3102 or
DABK-3103
@OP t 31 02
or
@op t* 3103
@when no disc is
loaded
no ** di Sc
@when a disc is
loaded
01010000
CDS-3100 ana
seer
eat
cece
|
Romans
|
eee
|
version
display
eee | Version a
eae [ACTUAL TiMg =
tras lights
It no disc is loaded Display betore key
01 01 ** 00.00
CDP-3100
1-12. PRECAUTIONS FOR TRANSPORTING
CDP-3100
When repacking CDP-3100 to transport it, etc., use a tray
stopper as shown below and lock the disc table.
Part required:Tray stopper (Part No. 3-182-547-01)
Locking .
1. Tum on the_power switch of CDP-3100.
2. Press the key so that the disc table
comes out.
3. Check that there is no disc on the disc table and tum off
the power switch.
4. Attach the tray stopper between the disc table and front
panel as shown in the figure.
5. Push in the disc table slowly with your hand.
TRAY STOPPER
DISC TABLE
|-9 €)