Sony CDP-3100 - Rack Mounting; Installation of Dabk-3101 Memory Board (Option)

1-6. RACK MOUNTING
By
using
a
mount
board
on
the
market,
CDP-3100
can
be
mounted
in
a
19-inch
standard
rack
conforming
to
EIA
specifications.
Use mount boards above 3U.
Recommended
mount
board
(Settsu
Kinzoku
Kogyo
Co.,
Ltd)
e
Bracket:RHS-1335MB-AO
e Shelf:RHS-1238SL-BO
Procedure
1.
Bore
holes
in
the
mount
board
according
to
the
mount
pitch of the CDP-3100 shown in the figure.
2.
Remove
the
four
screws
securing
the
legs
at
the
bottom
of
the
unit.
Screws (+ PSW 3 x 8)
Screws (+ PSW3x8) €
3.
Using
the
attaching
screws
(PSW3
x
20),
secure
CDP-
3100
and
the
legs
to
the
mount
board
as
shown
in
the
figure.
.
Note:
Use
screws
of
the
length
shown
in
the
figure.
Using
screws
that
are
longer
than
the
specified
length
may
cause
the
unit
to
break
down,
etc.
Screw length
Note:
After
mounting
the
unit
in
the
rack,
do
not
cover
the
vents
at
the
top
of
the
unit.
1-4 (E)
1-7. INSTALLATION OF DABK-3101 MEMORY
BOARD (OPTION) —
Always turn off the power switch before installing DABK-
3101. :
Adjustments need not be carried out after it is installed.
Procedure
1. Place CDP-3100 upside down so that its bottom faces up.
2. Remove the screws shown in the figure and remove the
hold plate.
Screw (+ PSW 3 x 8)
Hold plate
3. Insert DABK-3101 into the connector of the AU-183 board
as shown in the figure.
4. Adjust the projection of DABK-3101 to the hole of the hold
plate and secure with the screws. |
Hold plate
CDP-3-100