Sony CDP-991 - Tape Recording Program Management; Program Playback and Auto Space Details

4 Program the selections for side B.
Repeat step 2.
5 Press >:
Ss >
Ses
To play the selections for side B
When the selections for side A are played, the player will
pause. Set the tape to the beginning of side B (‘‘B” lights
up.), then press B or If.
When the program being played is on side A, (%»] appears.
When it is on side B, [22] appears.
To stop playing
Press @.
You can play the same program repeatedly as fong as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playing
mode.
The program will be erased.
To erase the entire program
Press @™@ once during stop; twice during play.
The program is also erased when you turn off the player.
To check your program
Press CHECK the first selection in the program will be
displayed.
Each time you press CHECK, the next selection in the
program will be displayed. When CHECK is pressed after
the last selection, ‘“- END -” appears for 1 second and
then the display returns to the initial display.
To Change Your Prog
For operation, see page 20.
When you use the auto space function
All the blank spaces between selections, whether short or
long, will automatically be set uniformly to 3 seconds.
Therefore, playing time displayed for each selection will
include additional 3 seconds. (page 31)
— You have programmed a selection number over 24.
— The total time is exceeded 100 minutes.
To check the remaining time
Press TIME/MEMG once to see the remaining time of the selection being
played; twice to see the total remaining time; once more to return to the
initial display.
If you have inserted a pause, the display shows the total remaining time untit
the pause.
Your program is erased when:
* You change the continuous play mode.
* You turn off the power during program play.
25