Sony CDP-991 - Multi-disc Programming; Sequencing Up to Six Discs

DY-X-}[olar-ilale Ma tal-M age halite Ol ae|-] ame) MO) om Koll oie BD) [yer
- Multi-disc Program
Multi-disc program allows you to program selections on one disc after another. You
can choose up to 24 selections from up to six discs for playing in any desired order.
3 Program desired selections on the first disc.
Press the appropriate numeric buttons or press
</> P1 and PROGRAM.
For details, see page 24.
Chosen
selection Order
a
Current selections
!
1] 3] [s}
Total time
26
4 Replace the first disc with the second one.
muLT!
Lights up.
Remove the disc, “MULTI PGM"” is displayed
and “MULT?” lights up in the window. Insert the
second disc, ‘“*DISC-2*” is displayed.
5 Repeat steps 3 and 4 to program additional
selections.
Up to 24 selections from up to 6 discs can be
programed. The total playing time from the first
disc is displayed for the time display.
To proceed to program selections to be recorded on
side B
Press II to put a pause and then program selections to be
recorded on side B.
If you press B by mistake when inserting the second disc:
The multi-disc program will be overriden by the continuous
play mode. Note that the programmed selections on the
first disc will be cancelled at this time.
To check the current disc number
Press TIME/MEMO (or TIME on the remote commander)
during stop. The disc number will be displayed.
To program selections on the same disc
You can program selections on the same disc again
The following functions cannot be conducted on Multi-disc programs.
* Repeat play
* Program bank
If you set the auto space function
The auto space cannot be set during multi-disc programming. Be sure to set
the auto space before programming.