Sony CDP-C445 - Time Fade for Gradual Playback End; Setting and Executing Time Fade; Specifying Tape Duration for Fade; Cancelling Time Fade Function

Fading Out at the Desired Time — Time Fade
You can have play fade out at the end by specifying the play duration. Once the time
fade is set, it functions twice for editing both sides of a tape. You can change discs
without cancelling this function. The fade time is preset to 5 seconds, but you can
change it to last from 2 to 10 seconds (page 12). You cannot use the time fade
function when you use the DIGITAL OUT (OPTICAL) connection.
Setting Time Fade and Playing
Tie 2-B Í u
1 Press EDIT/TIME FADE twice during stop (or
once during pause).
EDIT/TIME FADE
2-A Specify a commercially available
tape length.
moss D 2 DE g E
PS TIME
c- sue
Each time you press > PI, the display changes to
give you the following duration:
i --.-— — C-46 (23.00) —> C-54 (27.00) ]
C-90 (45.00) <— C-74 (37.00) <-C-60 (30.00)
By pressing I¢, you can reverse the above cycle.
22
2-B Specify any tape length for one side
of your tape.
Set the desired play duration using numeric buttons.
Example:
To set to 27 minutes 15 seconds, press
(2), 2), 0 ana [s).
You need not press buttons for seconds, unless
required.
Note
The duration can be set to 99 minutes 59 seconds.
Play starts.
After the specified time, play fades out and
pauses. Tape side “B” lights up. Press > or if to
resume playing for the other side of the tape. If you
press FADER, fade in will start. When play fades
out for the second time, the player pauses and the
time fade function is cancelled.
To cancel time fade
Press EDIT/TIME FADE once again, or press 44 or >>
during play.
When a disc ends before the specified time
The time fade function remains effective. You can change discs and continue
playing until the specified time is up.
To display the time remaining until the time set
Press TIME during play until the total remaining time appears (page 9).