Sony CDP-C445 - Player Maintenance and Specifications; Cleaning Player Exterior and Discs; Technical Specifications Summary

Chapter 5 Additional information
Maintenance Specifications
i C ct Disc Pi
Cl - Pi ompa sc Player
an crept a eal E
; vak : Laser Semiconductor laser
Clean
the
cabinet,
panel
and
controls.
with
a
soft
cloth
lightly
Wavelength
780-790
nm
moistened with a mild detergent solution. Do not use any
type of abrasive pad, scouring powder or solvent such as
alcohol or benzine.
Frequency response 2 Hz-20 kHz (+0.5 dB)
Signal to noise ratio More than 107 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0035%
Channel separation More than 100 dB
Cleaning Discs
Outputs
LINE OUT Output level 2 V
When
a
disc
becomes
dirty,
clean
it
with
a
cleaning
cloth.
(phono
jacks)
Load
impedance
over
10
kilohms
Wipe
the
disc
from
the
center
out.
DIGITAL
OUT
Wave
length
660
nm
(OPTICAL) Output level -18 dBm
(optical output
connector)
PHONES Output leve! max. 10 mW
(stereo phone jack) Load impedance 32 ohms
General
Power requirements Model for the USA and Canada
120 V AC, 60 Hz
Model for Australia
240V AC, 50/60 Hz
Power consumption 14W
Do
not
use
solvents
such
as
benzine,
thinner,
commercially
Dimensions
(approx.)
430
x
125
ae
fam
wiwa)
available
cleaners
or
anti-static
spray
intended
for
analog
(17x
5
x15
h
inches)
discs.
Including
projecting
parts
and
controls
Mass (approx.)
5.7
kg ,
net
(12
Ibs
100z)
Remote Commander RM-D335
Remote control system Infrared control
Power requirements 3 V DC with two size AA batteries
(IEC designation R6)
Dimensions 45 x 20 x 185 mm (w/h/d)
(1'6 x "/16 x 7/8 inches)
Mass 100 g {3.5 02) including batteries
Design and specifications are subject to change without
notice.
25