Searching a track by listening to
track passages -
ZAPPINTM
While playing back short track passages in a
CD
or
USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN
mode
is
suitable for searching for a
track in shuffle
or
shuffle repeat mode.
Radio
Storing
and
receiving
stations
Caution
When tuning in stations while driving, use Best
Tuning
Memory
(BTM) to prevent an accident.
ZAP Select button
~
(BACK)
1 Press
(ZAP)
during playback.
After
"ZAPPIN"
appears in the display,
playback starts from a passage
of
the next
track.
The
passage
is
played for the set time, then a
click sounds and the next passage starts.
2 Press the select button or
(ZAP)
when
a track you want to listen is played
back.
The
track that you select returns to normal
play mode from the beginning.
To search a track by
ZAPPIN
mode again,
repeat steps I and 2.
Tips
•
You
can select the playback time from about 6
seconds/9 seconds/3D seconds (page
19).
You
cannot select the passage
of
the track
to
playback.
• Press
(SEEK)
+/-
or
CD/CD
(ALBUM
-/+)
in
ZAPPIN mode
to
skip a track
or
album.
• Pressing
~
(BACK) also confirms a track to
playback.
Tuning automatically
1 Select the band, then press
(SEEK)
+/-
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Receiving the stored stations
1 Select the band, then press a number
button
(CD to
®).
Storing manually
1 While receiving the station that you
want to store, press and hold a
number button
(CD to
®)
until
"MEM" appears.
Note
If
you try to store another station on the same number
button, the previously stored station will be replaced.
Storing automatically - BTM
1 Press
(SOURCE)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly. You can select from
FM
I, FM2,
FM3,
AMI
or
AM2.
2 Press and hold the select button.
The setup display appears.
3 Press the select button repeatedly
until "BTM" appears.
4 Press
(SEEK)
+.
The
unit stores stations in order
of
frequency
on the number buttons.
A
beep
sounds when the setting is stored.
e----i------'
The
part of each track to
playback in ZAPPIN mode.
t
~
.....
'
U
Track
-
Tip
If
you know the frequency
of
the station you want
to
listen
to,
press
and
hold (
SEEK)
+/-
to
locate the
approximate frequency, then press
(SEEK)
+/-
repeatedly
to
fine adjust
to
the desired frequency
(manual tuning).
12
To Next Page
Loading...
