Dimensions: Approx.
178
x 50 x
182
mm
(7
I/
s
x 2 x 7
1
/
4
in) (w/hld)
Mounting dimensions: Approx.
182
x
53
x
162
mm
(7 '/4 x 2 I/
s
x 6
1
12
in) (w/hld)
Mass: Approx.
1.3
kg
(2
Ib
14
oz)
Supplied accessories:
Card remote commander: RM-XlSI
Parts for installation and connections (I set)
Optional accessories/equipment:
BUS cable (supplied with an RCA pin cord):
RC-61 (I m), RC-62 (2 m)
Source selector: XA-C40
AUX-IN selector: XA-300
USB connection cable for iPod: RC-I
OOIP
HD
Radio™
tuner:
XT-IOOHD
Your
dealer
may
not
handle
some
of
the above listed
accessories. Please ask the
dealer
for detailed
information.
Design
and
specifications are subject to change
without notice.
• Halogenated flame retardants are not used
in
the
certain printed wiring boards.
• Halogenated flame retardants are not used
in
cabinets.
• Packaging cushions are made from paper.
Troubleshooting
The
following checklist will help you remedy
problems you may
encounter
with
your
unit.
Before
going
through the checklist below,
check
the
connection and operating procedures.
If
the
problem
is
not
solved, visit the following
support
site.
Support site
http://esupport.sony.com
http://www.xplodsony.com/
GeneraHtf';.·:0:
tJ:;i'~1$\ii:;~
..
/ f
'.,;,
No power is being supplied to the unit.
• Check the connection or fuse.
•
If
the unit
is
turned off and the display disappears,
it
cannot be operated with the remote commander.
--+
Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The ATT function
is
activated, or the Telephone
ATT
function (when the interface cable
of
a car telephone
is
connected to the
ATT
lead)
is
activated.
• The position
of
the fader control "FAD"
is
not set for
a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 19).
• An optional power amplifier
is
connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
--+
Store again into the memory.
• The power supply lead or battery has been
disconnected or
it
is
not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If
no
operation
is
performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
--+
Set "DEMO-OFF" (page
19).
The display disappears from/does not appear
in
the display window.
• The dimmer
is
set "DIMMER-ON" (page
19).
• The display disappears if you press and hold
(OFF).
--+
Press and hold
(OFF)
on the unit until the
display appears.
• The connectors are dirty (page
21
).
continue to next page--+
-
23
To Next Page
Loading...
