To display the clock, press
(DSPL).
Press
(
DSPL)
again to return to the previous display.
Tip
You
can set the clock automatically with the RDS
feature (page
13). (CDX-MR50IP)
Detaching
the
front
panel
You can detach the front panel
of
this unit to
prevent theft.
Caution alarm
If
you
tum
the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound
if
the built-in
amplifier is used.
1 Press
(OFF).
The unit is turned off.
2 Press
(OPEN).
The front panel
is
flipped down.
3 Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop
or
put
excessive pressure on the front
panel
and
display window.
• Do not subject the front panel to heat/high
temperature
or
moisture. Avoid leaving it in a
moored boat.
Attaching the front panel
Place the hole ®
of
the front panel onto the
spindle
® on the unit, then lightly push the left
side in.
Press
(SOURCE)
on the unit (or insert a disc) to
operate the unit.
Note
Do
not
put
anything on the inner surface
of
the front
panel.
Inserting
the
disc
in
the
unit
1 Press
(OPEN).
2 Insert the disc (label side up).
3 Close the front panel.
Playback starts automatically.
Ejecting the disc
1 Press
(OPEN
).
2
Press~.
The disc is ejected.
3 Close the front panel.
•
7
To display the clock, press
(DSPL).
Press
(
DSPL)
again to return to the previous display.
Tip
You
can set the clock automatically with the RDS
feature (page
13). (CDX-MR50IP)
Detaching
the
front
panel
You can detach the front panel
of
this unit to
prevent theft.
Caution alarm
If
you
tum
the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound
if
the built-in
amplifier is used.
1 Press
(OFF).
The unit is turned off.
2 Press
(OPEN).
The front panel
is
flipped down.
3 Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop
or
put
excessive pressure on the front
panel
and
display window.
• Do not subject the front panel to heat/high
temperature
or
moisture. Avoid leaving it in a
moored boat.
Attaching the front panel
Place the hole ®
of
the front panel onto the
spindle
® on the unit, then lightly push the left
side in.
Press
(SOURCE)
on the unit (or insert a disc) to
operate the unit.
Note
Do
not
put
anything on the inner surface
of
the front
panel.
Inserting
the
disc
in
the
unit
1 Press
(OPEN).
2 Insert the disc (label side up).
3 Close the front panel.
Playback starts automatically.
Ejecting the disc
1 Press
(OPEN
).
2
Press~.
The disc is ejected.
3 Close the front panel.
•
7
To Next Page
Loading...
