– 11 –
2 There are two types of “gear, tray” available: screw fastening type and rubber fit type.
For the rubber fit type of “gear, tray” , fit the rubber in the boss on the “gear, tray” .
Do not allow the rubber to project. Take care not to damage the claw.
1 Pass a pin of 1.5 mm diameter through the holes in the “gear , tray ” and the “gear, tray rock”
and align these holes with the hole in the “base, changer”.
OK NG
pin
gear
gear, tray
gear, tray
rubber
gear, tray rock
gear (C), relay
claw
base, changer
• NOTE FOR INSTALLATION OF THE “BASE, CHANGER”
It is important for the CD changer mechanism to ensure a proper
alignment between the “gear, tray” and the “gear, tray rock”.
Ver 1.1 2000. 06
To Next Page
Loading...
