Customizing your Sony CLIÉ™ handheld (Preferences) 91
Changing the Network preferences
3 Tap the arrow V next to Connection type and select one of
the following connection types.
• PPP: Point-to-Point Protocol
• SLIP: Serial Line Internet Protocol
• CSLIP: Compressed Serial Line Internet Protocol
Tip
If you are not sure, try PPP; if that doesn't work, ask your Internet Service Provider
or your System Administrator for the correct connection type.
4 Tap the arrow V next to Idle timeout and select one of the
following options.
• 1 Minute: Waits one minute before dropping the connection when you open
another application that does not use the network.
• 2 Minutes: Waits two minutes.
• 3 Minutes: Waits three minutes.
• Never: Keeps your PPP or SLIP connection open until you turn off your CLIÉ
handheld (or until it times out).
Note that this option will be more costly than others.
5 Tap the Query DNS check box to deselect it.
6 Enter the IP address for the Primary and Secondary DNS
(Domain Naming System).
Ask your Internet Service Provider or System Administrator for the
correct Primary or Secondary DNS IP numbers.
7 If you need to enter the CLIÉ handheld’s IP Address, tap the
IP Address check box and display a permanent IP address
field below the check box.
Normally, you do not have to enter this IP address. If you are not sure,
select Automatic and go to step 9.
8 Enter the CLIÉ handheld’s IP Address.
9 Tap OK.
To Next Page
Loading...
