Sony DPS-R7 - REVC Block Parameters; REVC Parameters for ST-ST Type; REVC Parameters for MONO-ST Type

Reverberation Block (1) — REVC Block
This block is used comonly with both the ST-ST type and the
MONO.ST type algorithm.
List of REVC sub-block parameters for ST-ST
-" Parameters | MIN and MAX
reverb level(ch1, ch2) 0 ~ 100%
reverb phase(ch1, ch2) normal/inverse
direct level(ch1, ch2) 0 ~ 100%
normal/inverse
direct phase(ch1, ch2)
The display shows the blocks to be able to edit.
B EDIT
db f 1711)
> REVE REV
$
PRE-EF POST-EF INPUT >
Input : direct. _ Output
ochi
ch2
direct
REVC refers to other than REVS.
List of REVC sub-biock parameters for MONO-ST
Parameters — MIN and MAX
reverb level(ch1, ch2) 0- 100%
reverb phase(ch1, ch2) normal/inverse
direct level(ch1, ch2) 0-100%
direct phase(ch1, ch2) normal/inverse
REV1 outputlevel(cht,ch2) | 0- 100%
REV1 output phase(ch1, ch2) normal/inverse
send level(ch1, ch2) 0-100%
send phase(ch1, ch2) normal/inverse
The display shows the blocks to be able to edit.
| 4 EDIT
| C 1712)
PREVE REV
POS
1 REV2
FPRE-EF T-EF IWPUT >
direct oes
Input
:
SAO
R
deta
:
reverberation.
ORE
fy
on
be
chiot+t5——e[_pnevi__
eee
or
send
cht
\7-:\7
ENA
be
ch2
©
Pan’
ENG
REV2 oo
reverberation’:
S
directo
Pe
REVC refers to other than REV1 and REV2. eens
PARAMETERS OF EACH BLOCK 2 3
49019 JATH — (1) 4901q UORNesqI9AIY/AIOIg UONesaqIBABY