Help Guide
Digital Still Camera
DSC-RX0M2
TC/UB Settings
The time code (TC) and the user bit (UB) information can be recorded as data attached to movies.
Menu item details
TC Preset:
Sets the time code.
TC Reset:
Resets the time code.
UB Preset:
Sets the user bit.
UB Reset:
Resets the user bit.
TC Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to NTSC.)
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
Note
When you flip the monitor to shoot a self-portrait, the time code and user bit are not displayed.
How to reset the time code
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander (sold separately).
How to set the user bit (UB Preset)
MENU →
(Setup) → [TC/UB Settings] → setting value you want to change.
1
MENU →
(Setup) → [TC/UB Settings] → [TC Preset], then press the (Enter) button.1.
Press the up/down buttons and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
2.
When [24p] is selected, you can select the last two digits of the time code in multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
*
Set the other digits following the same procedure as in step 2, then press the
(Enter) button.3.
MENU →
(Setup) → [TC/UB Settings] →[TC Reset], then press the (Enter) button.1.
MENU →
(Setup) → [TC/UB Settings] → [UB Preset], then press the (Enter) button.1.
Press the up/down buttons and select the first two digits.2.
Set the other digits following the same procedure as in step 2, then press the
(Enter) button.3.
To Next Page
Loading...
