1. Set the mode dial to (Sweep Panorama).
2. Point the camera at the subject.
3. While pressing the shutter button halfway down, aim the camera at one end of the desired
panoramic composition.
(A) This part will not be shot.
4. Press the shutter button fully down.
5. Pan the camera to the end of the guide in the direction of the arrow on the monitor.
(B) Guidance bar
Note
If the entire angle of the panoramic shot is not achieved within the set time, a gray area occurs in the
composite image. If this happens, move the product faster to record the full panoramic image.
When [Wide] is selected for [Panorama: Size], the entire angle of the panoramic shot may not be
achieved within the given time. If this happens, try shooting after changing [Panorama: Size] to
[Standard].
Since several images are stitched together, the stitched part may not be recorded smoothly in some
cases.
To Next Page
Loading...
