Sony EV-C500E - Cutting Unwanted Scenes (During Playback)

DUAL MODE
@ REC SHUTTLE ring
COUNTER tt PAUSE
RESET
Note
The picture may be distorted a
moment at the cut-out point
{recording end point).
22 Advanced Operations
During Playback
You can re-record onto an unwanted portion of a pre-recorded cassette using the
DUAL MODE SHUTTLE ring on the VCR.
1 Press 1! PAUSE at the end of the unwanted scene during playback.
The VCR enters playback pause mode.
2 Press COUNTER RESET on the VCR to reset the linear time counter to
“OHOOMOOS.”
:
3 Turn the DUAL MODE SHUTTLE ring on the VCR until the beginning of the
unwanted scene appears on the screen.
When you release the ring, the VCR enters playback pause mode.
Use
<
DIRECTION
>
on
the
Remote
Commander
to
rewind
or
advance
the
picture
frame by frame when searching for more specific points.
4 Press @ REC.
The VCR enters recording pause mode.
5 Select a new programme source for re-recording.
6 Press if PAUSE again to release the pause when the scene to be recorded begins
to appear on the screen.
Recording starts.
7 Press @ STOP when the linear time counter shows “OHOOMO00S.”