Sony EV-C500E - Editing onto the Other VCR

Notes
« When connecting two VCRs, do
not connect them so that both
VCRs are used as a recording
VCR and a playback VCR
simultaneously. Doing so may
cause a humming noise.
* Ht your recording VCR is equipped
with the S VIDEO input connector,
you can use the S VIDEO cable
(not supplied) to connect to the
LINE OUT1 S VIDEO connector on
this VCR. This connection gives
you a higher quality picture than
using the video cable.
* If your recording VCR is a
monaural unit, make connections
using the VMC-910MS/920MS
cable (not supplied).
* if your recording VCR is a EURO
21-pin type, use the VMC-216
cable (not supplied).
» PLAY
This VCR B STOP.
(Playback VCR)
ft PAUSE
——
Other VCR (Recording VCR)
26 Editing
Editing onto the Other VCR
Here's how to edit from this VCR (as the playback VCR) onto the other VCR (as the
recording VCR).
Before You Begin
Press EDIT on this VCR so that the EDIT indicator lights up.
Note
If the other VCR has an editing function, it should also be selected to improve
reception.
Operation é
1 Turn on the other (recording) VCR and insert a blank cassette.
2 Insert a source cassette into this (playback) VCR.
3
Locate
the
playback
starting
point
and
select
playback
pause
mode
onthis
VCR.
4 Locate the recording starting point and select recording pause mode on the other
VCR.
5 Press il PAUSE on both VCRs.
For best results, press Il PAUSE on this VCR just before pressing Il PAUSE on the
other VCR. When you've finished editing, press & STOP on both VCRs.