35
Setup Menu
<MULTI FORMAT>
S03
FREQUENCY or
CAMERA FORMAT mode
setting changes take effect
only after the CCU power
supply is turned off and
then on again.
FREQUENCY
HD 1.001
, 1.000 Selects the operating frequency.
SD (525NTSC)
, (625PAL)
CAMERA FORMAT When FREQUENCY is set to
1.001: 1080/59.94I
, 1080/
29.97PsF, 1080/59.94P, 1080/
23.98PsF, 720/59.94P, 1080/
59.94I (RGB444), 1080/
29.97PsF (RGB444), 1080/
23.98PsF (RGB444), 1080/59I (2×),
720/59P (2×)
When FREQUENCY is set to
1.000: 1080/50I, 1080/25PsF,
1080/50P, 1080/24PsF, 720/50P,
1080/50I (RGB444), 1080/25PsF
(RGB444), 1080/24PsF (RGB444),
1080/50I (2×), 720/50P (2×)
Selects the transmission format.
FRAME CONVERT
DELAY
0.8, 1.2, 1.6
Sets the output delay for framerate-converted
signals. (Displayed only when FREQUENCY HD is
set to 1.001.)
CCU VIDEO
CONVERT
DSB
, ENB Sets video conversion. When CAMERA FORMAT is
set to 1080/59.94P or 1080/50P, set to ENB to
convert/output 720/59.94P or 720/50P signal from
the DRX board. To set to ENB, set FRAME
SYNCHRO in RETURN SETUP (S07) to ON.
Tip: When CCU VIDEO CONVERT is set to ENB,
the CCU internal video conversion is delayed, so
adjust the camera's signal by advancing it as
necessary.
2× MODE 0, 1
, 2 Sets the output format to 2× frame output. The CCU
output format changes.
0: Output by aligning with Horseshoe-shaped field.
(Compatible with SR-R1000.)
1: Output by aligning with field. (Compatible with
servers manufactured by EVS.)
2: Output by aligning with frame. (Compatible with
SRW-1/5800.)
Displayed only when CAMERA FORMAT is set to
1080/59.94I (2×), 1080/50I (2×), 720/59.94P (2×) or
720/50P (2×).
BIT DEPTH 10bit, 12bit Sets the output bit length to RGB 4:4:4.
The CCU output format changes.
Displayed only when CAMERA FORMAT is set to
1080/59.94I (RGB444), 1080/29.97PsF (RGB444),
1080/23.98PsF (RGB444), 1080/50I (RGB444),
1080/25PsF (RGB444) or 1080/24PsF (RGB444).
3G-SDI Level A, Level B
Selects SMPTE425 Level A or SMPTE425 Level B
for 3G-SDI output.
HD-SD DELAY Line (90H)
, Frame (1F), 0-Delay Sets the phase output for SD signals down
converted from this unit’s HD signals.
COMPONENT RGB, YCD
Selects the component signal connector’s output
format.
(Displayed only when HKCU1003 is installed.)
SYSTEM OPERATION
Page name
Page No.
Item Settings Description
Note
To Next Page
Loading...
