When you connect a DVD player
or DVD recorder
You can use the DVD input button on the
remote
to
control your DVD player
or
DVD
recorder. You may need to change the factory
setting
of
this button depending on the remote
supplied with this receiver. The factory setting
for the remote
is
shown in the table below:
Remote Factory setting
Tips
• To output the sound
of
the
TV
from the speakers
connected to the receiver, be sure to
- connect the audio output
jacks
of
the TV to the
TV IN
jacks
of
the receiver.
- turn
off
the
TV's
volume
or
activate the
TV's
muting function.
• All the digital audio
jacks
are compatible with
32 kHz, 44.1 kHz, 48 kHz, and 96 kHz sampling
frequencies.
•
RM-AAU022 DVD player (Change the factory
setting
if
you connect a DVD
recorder)
RM-AAU023 DVD recorder (Change the
factory setting
if
you connect a
DVD player)
To change the factory setting
ofthe
DVD input
button on the remote, see "Changing button
assignments" (page 63).
Notes
•
To
input multi channel digital audio from the DVD
player, set the digital audio output setting
on
the
DVD player. Refer to the operating instructions
supplied with the DVD player.
• To output sound from the front speakers and the
subwoofer only when you select
DVD
input, be
sure to:
- connect your DVD player to the
DVD
COAX IN
jack
on the receiver.
- press 2CH.
• When connecting optical digital cords, insert the
plugs straight
in
until they click into place.
• Do not bend or tie optical digital cords.
• Be sure to connect the video output
of
the DVD
player, DVD recorder and
VCR
to the TV, so that
the image
is
displayed on the TV. Refer to the
operating instructions
of
each connected
component for details.
• You cannot do recording on the DVD recorder or
VCR via this receiver. For details, refer to the
operating instructions supplied with the
DVD
recorder
or
VCR.
23
GB
To Next Page
