Sony HT-SS2300 - Tuner Operations; Listening to FM;AM Radio

Tuner Operations
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
Listening to FM/AM radio the receiver.
You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and
AM antennas to the receiver (page 24).
Tip
The tuning scale for direct tuning differs depending
on the area code as shown in the following table. For
details on area codes, see page 4.
Area code
FM
AM
D, UC, CA
100 kHz 10 kHz*
AU, TW, TH
50 kHz 10 kHz*
CEL, CEK
50kHz 9kHz
*The AM tuning scale can be changed (page 72).
1
2
~.--FMMODE
2 Press TUNING + or TUNING -.
Press TUNING + to scan from low to
high; press TUNING - to scan from high
to low.
The receiver stops scanning whenever a
station
is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
To select monaural audio, you can
- press FM
MODE repeatedly until the
"MONO" indicator lights up on the display.
- set
"FM MODE" in TUNER menu to "FM
MONO" (page 41).
To return to stereo mode, you can
- press PM
MODE repeatedly until the
"MONO" indicator on the display do not
light up.
- set
"FM MODE" in TUNER menu to "FM
AUTO" (page 41).
49
GB
•