Before using the receiver for the first time,
initialize the receiver
by
performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2
1
Press
lie!)
to turn off the
receiver.
2 Hold down
lie!)
for 5 seconds.
"CLEARING" appears on the display for
a while, then "CLEARED" appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Insert two
R6
(size-AA) batteries in the
RM-AAV022 (Models
of
area code V, VC,
CA only) or RM-AAV023 (Models
of
area
code CEL, CEK,
AV,
TW, TH only) Remote
Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds
of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
•
If
you do not intend to use the remote for an
extended period
of
time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings.
If
this
happens, reassign the buttons again (page 63).
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.
25
GB
•
To Next Page
