10
To remove the battery pack
Slide the POWER switch to OFF.
Slide the BATT RELEASE lever and
remove the battery pack.
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 12)/
access lamp (p. 14) are turned off. If you
remove the battery pack or disconnect the AC
Adaptor while the power is turned on, the
setting cannot be saved.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (see page 79 for the details of storage).
To use a power source from a wall
outlet (wall socket)
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Slide the POWER switch to OFF, then
press DISPLAY/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISPLAY/BATT INFO again
while the information is displayed.
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
BATT RELEASE
lever
Battery pack Charging time
NP-FH50 135
NP-FH60 (supplied) 135
NP-FH70 170
NP-FH100 390
DISPLAY/BATT INFO
Remaining battery (approx.)
Recording capacity (approx.)
To Next Page
Loading...
Need help?
General