18
Recording
In the default setting, the image quality is set to HD (high definition). To change the image
quality, refer to “Setting the image quality” (p. 43).
b Notes
• If you aim the lens towards a strong light source, such as car headlights or the sun, a “ghost” caused by the
lens may appear in the picture.
• If the access lamp is lit or flashing after recording is finished, it means data is still being written onto the
“Memory Stick PRO Duo” media. Do not apply shock or vibration to your camcorder, and do not remove
the battery or AC Adaptor.
• When a movie file exceeds 2 GB, the next movie file is created automatically.
• When the HOLD. switch D is set to the right, the buttons and touch panel cannot be operated (p. 20).
z Tips
• For types of “Memory Stick” media you can use in your camcorder, see page 2.
• You can check the recordable time and the remaining capacity, etc., by touching (HOME) A t
(MANAGE MEDIA) t [MEDIA INFO] (p. 44).
• The image is displayed in a smaller recording angle on the LCD screen of the main body (approx. 92%)
than when the image signal is output from A/V Remote Connector or HDMI OUT jack and viewing the
image on a monitor device.
To set the recording angle in detail, it is recommended to check the image displayed on the monitor device
before setting the recording angle.
(Movie)/ (Still)
select button E
PHOTO C
START/STOP B
(HOME) A
(Movie) lamp
(Still) lamp
HOLD. switch D
To Next Page
Loading...
Need help?
General