Using the SNC audio upload tool
22
4
Install the SNC toolbox following the wizard
displayed.
If the Software License Agreement is displayed,
read it carefully and accept the agreement to
continue with the installation.
Tip
You should be logged in as administrator to install
the software.
5
Click Finish. The installation is completed.
Using the SNC audio
upload tool
The SNC audio upload tool allows you to transmit sound
from the computer to the camera.
This section explains the setup and operations of the
SNC audio upload tool.
The SNC audio upload tool supports the following audio
data to be transmitted.
Notes
• Only one user can transmit sound to the camera.
Meanwhile, another user will not be able to transmit
sound to the camera.
• If proxy server is enabled, sound uploading to the
camera may fail. In that case, disable the proxy server.
• SNC audio upload tool may not operate correctly if
personal firewall software or antivirus software is used
in your computer. In this case, disable the
corresponding software.
• If you are using Windows XP Service Pack 2 or later,
Windows Vista, Windows 7 or Windows 8, disable
Windows Firewall. Otherwise SNC audio upload tool
will not operate correctly. To set Windows Firewall
see: “Configuring Windows Firewall” in “When using
Windows Vista” on page 27, or “Configuring
Windows Firewall” in “When using Windows 7” on
page 28, or “Configuring Windows Firewall” in
“When using Windows 8” on page 30.
Installing SNC audio upload tool
Install the SNC audio upload tool following the wizard
displayed.
If the Software License Agreement is displayed, read it
carefully and accept the agreement to continue with the
installation.
Audio CODEC Transmission rate
G.711 (µ-LAW) 64 kbps
G.726 40 kbps
G.726 32 kbps
G.726 24 kbps
G.726 16 kbps
AAC 128 kbps
AAC 64 kbps
To Next Page
Loading...
