MHC-EC99/EC79/EC69/EC99T/EC79T/EC69T.GB.4-131-117-11(1)
31
GB
Additional Information
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
ashes on the display.)
Connect the antenna properly.
Find a location and an orientation that
provide good reception, and then set
up the antenna again.
Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
Consult your nearest Sony dealer if the
supplied AM antenna has come o the
plastic stand.
Turn o nearby electrical equipment.
To change the AM tuning interval
e AM tuning interval is factory-preset
to 9 kHz or 10 kHz (for some areas: this
function is not available on the European
and Russian models).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn o the system.
2
Press DISPLAY to display the clock.
3
While holding down TUNING +, press
/.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
To improve tuner reception
Turn o the CD player/USB device
power by using the CD/USB power
management function. By default, the
CD/USB power is turned on.
Use buttons on the unit to turn o the
CD player/USB device power.
1
Press CD to select the CD function.
2
Press / to turn o the system.
3
After “STANDBY” stops ashing, press
DISPLAY to display the clock and
then press / while holding down
.
“CD/USB PWR OFF” appears. With
the CD player/USB device power
turned o, access time is increased. In
addition, when the TUNER function
is selected, power is not supplied to
the USB device, so it is not recognized
even if connected.
To turn on the CD player/USB device
power, repeat the procedure until
“CD/USB PWR ON” appears.
Continued
To Next Page
Loading...
