Sony MHC-EC69 - Specifications; Main Unit and Amplifier Specifications

MHC-EC99/EC79/EC69/EC99T/EC79T/EC69T.GB.4-131-117-11(1)
37
GB
Additional Information
To prevent a tape from being
accidentally recorded over (MHC-
EC99T/EC79T/EC69T only)
Break o the cassette’s overwrite
protection tab from side A or B as
illustrated.
Break o
the cassette
tab
To later reuse the tape for recording,
cover the broken tab with adhesive tape.
About a tape longer than 90 minutes
(MHC-EC99T/EC79T/EC69T only)
e use of the tape with more
than 90 minutes of play time is
not recommended except for long,
continuous recording or playback.
Cleaning the tape heads (MHC-
EC99T/EC79T/EC69T only)
Use dry- or wet-type cleaning cassette
(available separately) aer every 10 hours
of use, before you start an important
recording, or aer playing an old tape.
Failure to clean the tape heads can cause
degraded sound quality or an inability
of the unit to record or play tapes. For
details, refer to the instructions of the
cleaning cassette.
Specications
Main unit
Amplier section
e following measured at AC 230 V,
50/60 Hz (European and Russian models)
e following measured at AC 120, 127,
220, 240 V, 50/60 Hz (Other models)
MHC-EC99/EC99T
Front Speaker:
Power output (rated):
Low channel
50 W + 50 W (at 8 Ω, 1 kHz, 1%
THD)
High channel
50 W + 50 W (at 8 Ω, 8 kHz, 1%
THD)
RMS output power (reference):
Low channel
65 W + 65 W (per channel at 8 Ω,
1 kHz, 10% THD)
High channel
65 W + 65 W (per channel at 8 Ω,
8 kHz, 10% THD)
Subwoofer:
RMS output power (reference):
90 W (at 4 Ω, 80 Hz, 10% THD)
Continued
