12
GB
4 Place the sub woofer (MHC-RV999D
only).
To obtain a better bass reproduction, we
recommend you to place the sub woofer on
a solid floor where resonance is unlikely to
occur.
Notes
• Do not place the surround speakers on top of a TV.
This may cause distortion of the colors in the TV
screen.
• Always place the sub woofer vertically, keeping it a
few centimeters away from the wall.*
• If the sub woofer is placed in the center of a room, the
bass could be extremely weakened.* This is due to
the influence of the standing wave of the room. If this
happens, move the sub woofer away from the center
of the room or eliminate the cause of the standing
wave, by placing a bookshelf against the wall, etc.
• For MHC-RV888D, when mounting the surround
speakers on the wall, be sure to mount the speakers
on walls having sufficient thickness and strength
using commercially available screws.
* MHC-RV999D only
Speaker settings
To enjoy DVDs and other discs with multi-
channel sound and Dolby surround effects, the
speakers need to be adjusted. Set the distance
from the listening position to the speakers, and
the balance and level. Then use the test tone to
adjust the volume of each speaker to the same
level.
For details, see “Speaker settings” on page 34.
Use buttons on the remote for the operation.
1 Press ?/1 to turn on the system.
2 Press CLOCK/TIMER SET.
3 Press M or m repeatedly to set the hour.
4 Press ENTER.
5 Press M or m repeatedly to set the
minute.
6 Press ENTER.
The clock starts working.
To adjust the clock
1 Press CLOCK/TIMER SET.
2 Press M or m to select “CLOCK SET”, then
press ENTER.
3 Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
• You cannot set the clock in Power Saving Mode
(page 51).
Setting the clock
To Next Page
Loading...
Need help?
General
