Sony MHC-RV888D - Specifications

68
GB
Main unit
Amplifier section
MHC-RV999D
The following measured at AC 120, 127, 220,
230 – 240 V, 50/60 Hz
Continuous RMS power output (reference)
Front speaker: 100 + 100 watts
(6 ohms at 1 kHz, 10%
THD)
Center speaker: 40 watts (6 ohms at 1 kHz,
10% THD)
Surround speaker: 40 + 40 watts
(6 ohms at 1 kHz, 10%
THD)
Sub woofer: 110 watts (4 ohms at
1 kHz, 10% THD)
MHC-RV888D
The following measured at AC 120, 127, 220,
230 – 240 V, 50/60 Hz
Continuous RMS power output (reference)
Front speaker: 100 + 100 watts
(6 ohms at 1 kHz, 10%
THD)
Center speaker: 40 watts (6 ohms at 1 kHz,
10% THD)
Surround speaker: 40 + 40 watts
(6 ohms at 1 kHz, 10%
THD)
MHC-RV777D
The following measured at AC 120, 127, 220,
230 – 240 V, 50/60 Hz
Continuous RMS power output (reference)
100 + 100 watts
(6 ohms at 1 kHz, 10%
THD)
Inputs
VIDEO/SAT IN (audio) (phono jacks):
voltage 450/250 mV,
impedance 47 kilohms
GAME INPUT VIDEO (phono jack):
1 Vp-p, 75 ohms
GAME INPUT AUDIO (phono jacks):
voltage 250 mV,
impedance 47 kilohms
MIC (phone jack): sensitivity 1 mV,
impedance 10 kilohms
Outputs
VIDEO/SAT OUT (audio) (phono jacks):
voltage 250 mV,
impedance 1 kilohm
VIDEO OUT (phono jack):
max. output level
1 Vp-p, unbalanced, Sync
negative, load impedance
75 ohms
S VIDEO OUT (4-pin/mini-DIN jack):
Y: 1 Vp-p, unbalanced,
Sync negative,
C: 0.286 Vp-p, load
impedance 75 ohms
COMPONENT VIDEO OUT:
Y: 1 Vp-p, 75 ohms
P
B, PR: 0.7 Vp-p, 75 ohms
DIGITAL OUT (Square optical connector jack, rear
panel) (MHC-RV777D only)
Wavelength 660 nm
PHONES (stereo mini jack):
accepts headphones of
8 ohms or more
FRONT SPEAKER: Use only the supplied
speaker SS-RV999.
SURROUND SPEAKER (except for MHC-RV777D):
Use only the supplied
speaker SS-RS999D for
MHC-RV999D, SS-
RS391 for MHC-RV888D.
CENTER SPEAKER (except for MHC-RV777D):
Use only the supplied
speaker SS-CT391.
SUB WOOFER OUT: Use only the supplied
speaker SA-RV999D for
MHC-RV999D.
voltage 1 V,
impedance 1 kilohm
Specifications