34
GB
To obtain the best possible surround sound, set
the speakers you have connected and their
distance from your listening position.
Then use the test tone to adjust the volume and
the balance of the speakers to the same level.
Setting the speakers
1 Press DVD SETUP in stop mode.
The Setup Display appears.
2 Press M or m repeatedly to select
“SPEAKER SETUP”, then press
ENTER.
3 Press M or m repeatedly to select
“SIZE” or “DISTANCE”, then press
ENTER.
4 Press M or m repeatedly to select the
setup item, then press ENTER.
5 Press M or m repeatedly to select or set
a setting, then press ENTER.
To return to the default settings
Select the item to be returned to the default
setting and press CLEAR.
x SIZE
When you do not connect center, surround
speakers or sub woofer, or you move the
surround speakers, set the parameters for
CENTER, SURROUND and SUBWOOFER.
Since the front speakers setting is fixed, you
cannot change them.
The default settings are underlined.
* Except for MHC-RV777D
Notes
• When adjusting speakers, the sound may cut off for a
moment.
• Depending on the settings of other speakers, the sub
woofer may output excessive sound.
• When connecting a sub woofer, make sure to set the
“SUBWOOFER” setting to “YES”. If set to
“NONE”, no sound is output from the sub woofer.
• When you play a DVD that does not have sub woofer
output recorded, note that no sound is produced from
the sub woofer, even if “SUBWOOFER” is set to
“YES”.
Speaker settings
— SPEAKER SETUP
FRONT YES
CENTER* YES: Normally select this
position.
NONE: Select this when a center
speaker is not used.
SURROUND* YES
: Normally select this
position.
NONE: Select this when
surround speakers are not used.
SUBWOOFER YES
: Select this when a sub
woofer is used.
NONE: Select this when a sub
woofer is not used.
To Next Page
Loading...
Need help?
General
