38
GB
To improve tuner reception
When tuner reception is poor, set DVD player
power off by DVD power manage function.
DVD power is factory set to on.
Use buttons on the unit for the operation.
1 Press DVD.
2 Press ?/1 to turn off the system.
3 Press ?/1 while holding x.
“DVD PWR OFF” appears.
To set DVD power on
Repeat the procedure above and “DVD PWR
ON” appears.
Notes
• When “DVD PWR OFF” is selected, DVD access
time is increased.
• You cannot change the setting in Power Saving
Mode (page 51).
To change the AM tuning interval
(except for Saudi Arabian model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding PLAY
MODE/TUNING MODE on the unit, press ?/1
on the unit. When you change the interval, all
the AM preset stations are erased. To reset the
interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 51).
Tips
• The preset stations are retained for about a half day
even if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 37).
1 Press FUNCTION + or – repeatedly (or
TUNER/BAND on the unit) to switch the
function to TUNER.
2 Press BAND (or TUNER/BAND on the
unit) repeatedly to select “FM” or
“AM”.
3 Press TUNING MODE repeatedly until
“PRESET” appears.
4 Press TUNING + or – repeatedly to
select the desired preset station.
Listening to the radio
FrequencyPreset number
To Next Page
Loading...
Need help?
General
