Sony PCM-D50 - TEST MODE; Test Mode Operation

PCM-D50
15
SECTION 3
TEST MODE
̸·- -»¬ °®±ª·¼»- ¬¸» Ì»-¬ Ó±¼» ¬¸¿¬ ½¿² ¾» «-»¼ º±® ¬¸» º±´´±©·²¹
½¸»½µ ³±¼»-ò
1. Setting and Exiting the TEST MODE
‹ ̧°»- ±º ÌÛÍÌ ÓÑÜÛ ¿²¼ -»¬¬·²¹ ¬¸» ÌÛÍÌ ÓÑÜÛ
ï Í»¬¬·²¹ ¬¸» ÍÛÎÊ×ÝÛ ÓÑÜÛæ
øï÷ Ì«®² ±² °±©»® ¬± ¬¸» -»¬ò Ì«®² ¬¸» Ô×Ó×ÌÛÎ -©·¬½¸
±² ©¸·´» °®»--·²¹ ÅßóÞà ¾«¬¬±² ¿²¼ ÅÜ×Ê×ÜÛà ¾«¬¬±²
¿¬ ¬¸» -¿³» ¬·³»ò
‹ Û¨·¬·²¹ ¬¸» ÍÛÎÊ×ÝÛñÌÛÍÌ ÓÑÜÛ
̸» ÌÛÍÌ ÓÑÜÛ ·- ½¿²½»´´»¼ ¾§ ¬«®²·²¹ ±ºº °±©»® ø®»³±ªó
·²¹ ¬¸» ¾¿¬¬»®§÷ò
øÍ»» Í»½¬·±² ëò Ú´±© ݸ¿®¬ ±º ¬¸» ÌÛÍÌ ÓÑÜÛò÷
2. Initial State of the TEST MODE and Exiting Method
‹ ײ·¬·¿´ -¬¿¬» «°±² »²¬®§ ·²¬± ¬¸» ÌÛÍÌ ÓÑÜÛæ •ÑÕŒ ·- -»²¬
¬± ¬¸» ÐÝ ¬¸®±«¹¸ ÎÍóîíîÝò
Û¨¿³°´» ±º ÔÝÜ ¼·-°´¿§
Version
KeyChk+Fmt
DSP Loop
Lcd Contrast
Cluster Num
3. OK or NG Judgment
ÑÕ ±® ÒÙ ¶«¼¹³»²¬ ·² »¿½¸ ³±¼» ·- ®»¬«®²»¼ ¾§ ¿ ÔÝÜ ¼·-ó
°´¿§ ¿²¼ ¿ -¬¿¬«- ª·¿ ËßÎÌò
4. How the Power of Each Section is Handled in the
TEST MODE
ɸ»² ÌÛÍÌ ±® ÍÛÎÊ×ÝÛ ÓÑÜÛ ·- »²¬»®»¼ô ¬¸» -§-¬»³ ©·´´
µ»»° ¬¸» °±©»® -¬¿¬» ·² ¿ -¬¿¬» »¯«·ª¿´»²¬ ¬± ¬¸» ×¼´» -¬¿¬»ò ̸·-
·- º±® -§-¬»³ ¬± ½¸»½µ ¬¸» °±©»® ¼»ª·½» ±º »¿½¸ -»½¬·±² º±® ·¬-
±°»®¿¬·±²ò ر©»ª»® ¼«®·²¹ »¨»½«¬·±² ±º ¬¸» Í´»»° ½±³³¿²¼ô
¬¸» -§-¬»³ ©·´´ ¬¿µ» ½±²¬®±´ ¾¿-»¼ ±² ¬¸» Í´»»° -¬¿¬» -·²½» ¬¸»
-¬¿²¼¾§ ½«®®»²¬ ²»»¼ ¾» ³»¿-«®»¼ò
5. Flow Chart of the TEST MODE
6. Transitions in Each Mode
:
Version
KeyChk+Fmt
DSP Loop
Lcd Contrast
Cluster Num
RTC Int
Battery
DCIN
VBUS
Sleep
App LogOut
Log Output
Log Clear
Menu Init
Key Check
Version
:
START
After power-on,
idle or sleep state
END
Exit from TEST MODE
Power OFF
(Remove the battery)
LIMITER SW OFF
LIMITER SW ON
Press [A-B]+[DIVIDE]
at the same time
Release [A-B]+[DIVIDE]
Release [A-B]+[DIVIDE]
SERVICE MODE
established Menu Display
WWW.OURDEV.CN