70
White Clip
White clip
adjustment
settings
Setting
On / Off
Turns the white clip adjustment function on/off.
Note
Cannot be set when Gamma >Gamma Category is set to
S-Log2 or S-Log3.
Level
When Country is not set to PAL
Area.
90.0% to 109.0% (108.0%)
When Country is set to PAL Area.
90.0% to 109.0% (105.0%)
Sets the white clip level.
Detail
Detail adjustment
settings
Setting
On / Off
Turns the detail adjustment function on/off.
Level
–99 to +99 (±0)
Sets the detail level.
H/V Ratio
–99 to +99 (±0)
Sets the mix ratio between the H detail level and the V detail
level.
Crispening
–99 to +99 (±0)
Sets the crispening level.
Level Depend
On / Off
Turns the level dependence adjustment function on/off.
Level Depend Level
–99 to +99 (±0)
Sets the level dependence level.
Frequency
–99 to +99 (±0)
Sets the center frequency of the detail (detail thickness).
The detail is thinner the higher the center frequency, and
thicker the lower the center frequency.
Knee Aperture
On / Off
Turns the knee aperture correction function on/off.
Knee Aperture Level
–99 to +99 (±0)
Sets the knee aperture level.
Limit
–99 to +99 (±0)
Sets the detail limiter for both the white-side and black-side
directions.
White Limit
–99 to +99 (±0)
Sets the white-side detail limiter.
Black Limit
–99 to +99 (±0)
Sets the black-side detail limiter.
V Black Limit
–99 to +99 (±0)
Sets the black-side V detail limiter.
V Detail Creation
NAM / Y / G / G+R
Sets the signal source for creating the V detail to NAM (G or
R, whichever is higher), Y, G, or G+R.
Paint
Item Sub-item setting Description
To Next Page
