Sony RM-E700 - Page 10

Connection 4
Use this connection when you have another
manufacturer's recorder with an infrared remote
control unit. After connection, set the switches at the
rear of the RM-E700, and then store the tape
transport functions of the recorder’s remote control
unit. For the store operation, see page 18.
TV or monitor 1 Connect the RM-E700 and the recorder.
~ = Recorder
to audio/ to audio/video output
video input
Connect the TV (or monitor)
to the recorder.
to CONTROL L, REMOTE
or LANC @&
Connecting cable Connecting cable
{not supplied, page 54) (not supplied, page 54)
/
I
video (yellow) audio R (red)
audio L (white) audio L (white)
|
CONTROL
L
connecting
Connect
the
RM-E700
to
the
power
source.
Do not turn on the power until you finish all the connections,
Doing so, may cause a malfunction.
AC-D4L PP >
{supplied} to a wall outlet
lJ
video (yellow)
cable (supplied)
to DC IN 6V
ii
4 Set the switches at the rear. RECORDER section PLAYER section
Other switches may be at any position.
When an infrared jog/shuttle remote control unit is
not supplied, or it is not available on option to
To
release
the
pause
mode
of
the
recorder:
A
8
operate
your
video
equipment
—
Set
to
A.
by pressing the pause button — Set to A.
by pressing the play button > Set to B SHUTTLE MODE ; ;
by
pressing
the
record
button
>
Set
to
C.
When
an
infrared
jog/shuttle
remote
control
unit
is
supplied, or it is available on option to operate your
video equipment — Set to B.
«> Signal flow
You cannot use the jog/shuttle dial of the RECORDER section to
operate a video quipment of other manufacturers.
Continued on next page
16
17